Bully Dog 81222 Rapid Flow - Manual (Page 8)

9
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81222
8. Install the Passenger Front Piece Tail Pipe into the lower
pipe coming out of the Y Pipe. Ensure that the bend is di-
rectly over the axle. Secure the connection with a clamp.
At this point don’t tighten completely. Wait until the entire
exhaust is installed before tightening everything down
completely.
9. Install the Passenger Tail Pipe Tip in the Passenger Front
Piece Tail Pipe and hang from Hanger D. Secure with a
clamp.
10. Install the Driver Front Piece Tail Pipe into the upper pipe
coming out of the Y Pipe. Again ensure that the bend is
directly over the axle. Secure with a clamp.
11. Install the Driver Tail Pipe Tip in the Driver Front Piece Tail
Pipe and hang from Hanger E. Secure the connection with
a clamp.
12. Install the Muffler into the base of the Y Pipe. Secure with
a clamp.
Install Front Piece Tail Pipe
Hanger C
Y-Pipe
Install Tail Pipe Tip
Tail Pipe Tip
Hanger D
Connect Muffler to Y Pipe
Passenger Front Piece Tail Pipe
Hanger C
Driver Front Piece Tail Pipe
Muffler