Calculated Industries 4015 - Manual (Page 6)

[Feet] — Feet Key
This is an entry and conversion key. You
can enter whole or decimal numbers. You
can also use this key to enter values in
feet-inch-fraction format:
(2 [Feet] 1 [Inch]
1 [/] 2) . To convert a displayed value to
feet, press [Conv] [Feet] . Repeated
presses toggle between feet-inches and
decimal feet formats.
[Inch] — Inch Key
This is an entry and conversion key
(when used with the
[Conv] key). You can
enter whole or decimal numbers. You can
also use this key with the
[/] key to enter
fractional inch values. For example to
enter 3-3/4 inches, press
3 [Inch] 3 [/] 4 .
To convert a displayed value to inches,
press
[Conv] [Inch] . Repeated presses
toggle between fractional inch and deci-
mal inch formats.
[/] — Fraction Key
Enters a fraction. To enter a fraction,
enter the numerator, the fraction key
[/]
and then the denominator: 1 [/] 2 .
Fractions can be entered as proper
(1 or less – 1/2, 1/8, 1/16) or improper
(greater than 1 – 3/2, 65/64). If the
denominator (the bottom number) is
not entered, then the currently selected
fractional denominator is used.
[Rcl] [/]
6 – Measure Master Classic
™
4015-UG-B 4/4/03 12:29 PM Page 6