Calculated Industries 4015 User Manual
Page 7
displays the current fractional denomi-
nator and accesses the fractional setting
mode. See the “
Fractional Setting
” sec-
tion on page 15 for more information.
[Cu] — Cubic Key
Used with a dimension key (feet, inches,
yards, meters, etc.) to identify a volume
dimension. Example:
5 [Cu] [Yds]
.
[Sq] — Square Key
Used with a dimension key (feet, inches,
yards, meters, etc.) to identify an area
dimension. Example:
10 [Sq] [Feet]
.
[m] — Meters Key
This is an entry and conversion key
(when used with the
[Conv]
key). You can
enter decimal meters or convert a dis-
played dimension to decimal meters.
[cm] — Centimeters Key
This is an entry and conversion key
(when used with the
[Conv]
key). You
can enter decimal centimeters or con-
vert a displayed dimension to decimal
centimeters.
[mm] — Millimeters Key
This is an entry and conversion key
(when used with the
[Conv]
key). You
can enter decimal millimeters or con-
vert a displayed dimension to decimal
millimeters.
User’s Guide – 7
4015-UG-B 4/4/03 12:29 PM Page 7