Starting up – Barco MFCD 1219 (TS) User Manual
Page 18
Installation
18
To connect the video & sync signals:
1.
Connect one end of the appropriate video cable to the
corresponding video input of the monitor.
• Analog video: Connect to input (3)
• DVI: Connect to input (2)
2.
Connect the other end of the video cable to the video output of
your video source.
• Analog video: Computer graphics board with analog video
output
• DVI: Computer graphics board with digital video output
To connect the power:
1.
Connect one end of the proper power cable to the AC input of the
12V DC adapter.
2.
Connect the 12V supply of the 12V DC adapter to the DC input (1)
of the monitor.
3.
Connect the other end of the power cord to a grounded power
outlet.
Starting up
Proceed as follows:
1.
Switch on the computer.
2.
Switch on the display by pushing the Power key (1).
3.
If necessary, select a suitable resolution in the computer operating
system. Please refer to Appendix A, "Possible resolutions" in the
back of this manual.