Calculated Industries 6260 User Guide - Manual (Page 15)

[PC SEND]
When connected to a PC, sends the value
on the main display in decimal format to
the PC (see PC Interface section).
[ARC/CIRC]
First press identifi es a new
measurement as an Arc, second
consecutive press identifi es it as a Circle.
Three points must be measured for an
Arc; two points (diameter) or three points
must be measured for a circle. The
Ultra Scale Master Pro
will auto-close
three-point Arc or Circle measurements.
[MR] (Memory Recall)
First press displays the accumulative
Memory value; second consecutive
press displays Memory Count; third
consecutive press displays the Memory
Average. Repeated presses cycle back
through this list of values.
[SET] [MR] (Memory Clear)
Clears the accumulative Memory.
Directional Pad (D-PAD)
When a measurement is ended or closed,
pressing the D-Pad displays calculated
values (disabled during measuring). Also
used for setting Preferences, Height, and
Custom Scales.
U
SER’S
G
UIDE
— 13