Calculated Industries 6250 - Manual (Page 27)

MEASURING IRREGULAR SHAPES
OPERATING SEQUENCE
1. Press the [ON/CLEAR] key twice to clear the display.
Place the crosshairs over the fi rst point and press the
[MEASURE]
key.
2. Move to the second point and press the [MEASURE] key.
3. Move to the third point and press the [MEASURE] key.
4. Move to the fourth point and press the [MEASURE] key.
5. Move to the fi fth point and press the [MEASURE] key.
6. Move to the sixth point and press the [MEASURE] key.
7. Move to the seventh point and press the [MEASURE] key.
8. Move to the eighth point and press the [MEASURE] key.
The accumulated Lengths of the seven measured
segments will be displayed.
1 5
6
7
8
2
3
4
4
5
6
1
2
3 7
24 — U
LTRA
S
CALE
M
ASTER ®
8
AREA
PERIMETER
9. Press the [CLOSE+]
key. The total Area
is displayed. Once a
measurement is closed,
press the [PERIM] key to
display the Perimeter.
9
9