Calibrated Software MPEG2-X Create v1 - Manual (Page 41)

Page | 42
Manually configuring for 8-bit YUV422 Export in AME
1. Right-click on the source you are exporting from AME and from the drop- down menu choose’ Export Settings’ for
the A dobe Export Panel window to appear. In the ‘Export Settings’, please choose ‘QuickTime’ for the format
2. Click on the ‘Video’ Tab in the ‘Export Settings’
a. Choose the Calibrated MPEG2-X Create Compression Type that best matches your Sequence Settings in the
‘Video Codec’ drop down menu. (Please see the ‘Overview’ section at the beginning of this chapter to see
what Compression Type matches best with your Sequence Settings)
b. Make sure the ‘Quality’ slider is set to the bitrate you wish to encode to
c. Make sure the Width/Height are at either 1920x1080 or 1280x720 and PAR is at Square Pixels (1.0)
d. Make sure the Field Type matches the Calibrated MPEG2-X Compression Type you are exporting to -choose
‘Upper First’ for interlaced compression types or ‘Progressive’ for progressive compression types.
e.
Make sure the ‘Frame Rate’ matches the Calibrated MPEG2-X Compression Type you are exporting to –
please see the ‘Overview’ section at the beginning of this chapter to see the proper frame rates for the
different MPEG2-X Compression Types.
f.
Make sure that ‘Render at Maximum Depth’ is CHECKED
g.
Make sure that the Bit Depth is set to ’24 bit’
h. Make sure that ‘Use Maximum Render Quality’ is CHECKED
i.
Make sure that ‘Use Previews’ is NOT CHECKED
3. And you’re ready to export