Clay Paky ASTRORAGGI TWIN (24V 150W) - Manual

3
ENGLISH
ASTRORAGGI TWIN
24V 150W
• Minimum distance from target objects
The projector must be positioned in such a way
that objects struck by the beam are located at
least 0.1 m (4”) from the lens.
• Minimum distance of inflammable materials from any part of the fixture:
0.02 m (1”).
The fixture may be mounted on surfaces rated normally inflammable.
IMPORTANT: For better and more reliable operation of the projector, the ambient
temperature must not exceed 35° C (95° F).
Protection factor IP 20: the appliance is protected against penetration of solid bod-
ies more than 12mm (0.5”) in diameter (first digit 2), but can be damaged by spray,
jet, drip or rain water (second digit 0).
INSTALLING THE PROJECTOR 1
1
POWER SUPPLY AND SETUP 2
The projector is designed to operate at the voltage and frequency indicated on the
electrical data plate (2) located on the base.
Check that these two values correspond to the mains voltage and frequency.
IMPORTANT: the projector must be connected to a power supply circuit having
a proper earth system (Class I appliance).
• Electrical connections (supplied socket outlet)
• Connecting to the electrical power supply
The operations described in this heading must be carried out by a licensed electrician.
The projector must be wired up to the electrical power supply using the special sock-
et connector provided. It is good policy to connect projectors to the power supply by
way of dedicated switches, so that each can be turned on and off individually from
a remote station.
MAINTENANCE 3
IMPORTANT: isolate the projector from the electrical power supply before com-
mencing maintenance work of any description.
The maximum temperature on the outer surface of the projector under normal oper-
ating conditions is 80°C (176° F).
After switching off, do not remove any part of the projector for at least 2 minutes;
once this time has elapsed, the risk of a lamp exploding is practically zero.
If the lamp needs changing, wait a further 15 minutes to avoid the risk of burns.
In the event of a lamp exploding, the fixture is designed to prevent fragments of
glass from being scattered.
The lenses must be fitted at all times, and if visibly damaged must be replaced
promptly with genuine spares.
INSTRUCTION MANUAL
IMPORTANT: Read carefully. A thorough knowledge of the information and
prescriptions in this manual is essential for the correct and safe use of the
equipment.
• Unpacking
Open the box, remove the projec-
tor from the packing and place it on
a flat, horizontal surface.
Unpack the standard accessories
supplied with the fixture.
• Fitting the lamp
Refer to directions for replacement of the lamp given under heading 3 MAINTE-
NANCE.
• Installing the projector
The projector can be mounted in any position without its operating characteristics
being affected.
Fix the drilled plate (1) to the supporting structure and then fix the plate to the pro-
jector using four M8 nuts and four lock washers.
Make sure that the anchorage is stable before positioning the projector.
2
Mains
ENGLISH
PIN CONNECTION
1-2 Fan: must be powered up constantly when projector is in use.
3-4 Motor: can be constantly on, constantly off or connected
through a manual switch or lighting controller.
3-5 Lamps: can be off / on or connected through a manual
3-6 switch or lighting controller.
(4”)
0.1 m
24V - 150W
®