Clay Paky ASTRORAGGI TWIN (24V 150W) User Manual
Page 2
4
• Replacing the fuse
To replace the fuse unscrew fuse-
holder cap (11) and fit a new fuse of
the same type and rating as indicat-
ed on the label (12).
Refit the fuseholder cap and tighten
fully.
• Routine cleaning
To maintain the light output of the
projector undiminished, parts that
tend to accumulate dust and grease
must be cleaned periodically.
The projector will give long and trou-
ble-free service if these simple
guidelines are followed.
To remove dirt from the lenses and
filters, use a soft cloth moistened
with any liquid detergent suitable for
cleaning glass.
IMPORTANT: do not use solvents or
alcohol
Parts that need cleaning fre-
quently.
Internal parts should be cleaned once
a year by dislodging dust and dirt with
a brush and removing with a vacuum
cleaner.
CHECKS AND REMEDIES
POSSIBLE CAUSES
No electrical power supply.
Lamp expended or faulty.
Deposit of dust or grease.
Change lamp (see instructions).
Change lamp (see instructions).
Check that power is available at the
mains, that the fuses are intact and
that the lighting controller (if present)
is functioning correctly.
FAULTS
9
10
• Opening the projector
Unscrew the knob (3) and open the
cover (4) to access the lampholder
assembly.
Once the necessary work has been
completed, close the cover (4) and
tighten the knob (3).
• Installing the colour wheel
(optional)
Remove the colour wheel (5)
from its packaging and fit it on
the projector ensuring that clips
(6) are aligned with locations (7)
in the protective cone (8) located
inside the projector.
• Changing the lamp
Remove the lamp (9) from fitting (10)
by gripping it at the base. Remove the
new lamp (9) from its box and insert
into the fitting (10), ensuring that the
pins are positioned correctly.
CAUTION:
- When fitting a new lamp, read the manufacturer’s instructions carefully.
- The lamp must always be changed without delay if damaged or deformed by
heat.
TROUBLESHOOTING
4
PROJECTOR DOES NOT LIGHT UP
PROJECTION FAULTY
REDUCED BRIGHTNESS
•
• •
•
•
TECHNICAL DATA
CONSTRUCTION
FEATURES
Cooling
Forced ventilation cooling system using
axial flow fans.
Housing
• Steel and extruded aluminium.
• Epoxy powder coated finish.
Operating position
Will function in any position.
Weight and dimensions
Weight: 19 kg (41 lbs 13 ozs)
ELECTRICAL / MECHANICAL
SPECIFICATIONS
Power supplies available
• 200-240V 50/60Hz
• 100-120V 50/60Hz
The projector is designed to operate at
the mains frequency and voltage given
on the electrical data label on the base
of the appliance.
Lamps
N. 2 halogen lamps supplied indepen-
dently by means of built-in transformers:
• Type 24V 150W
- Cap GY 6.35
- Colour temperature 3300 K
- Luminous flux 6000 lm
- Average life 50 h
Power consumption
350VA a 230V 50Hz
Rotation speed of lamps
50 rpm
CONTROL SYSTEM
Simultaneous or sequential striking of
the lamps and motor rotation can be
delegated to an external controller.
5
7
6
5
8
4
3
(14.1”)
360
(17.7”)
450
(14.1”)
360
(13.8”)
ø 350
The products referred to in this manual comply with EC
Directives on:
• Low Voltage 73/23
• Electromagnetic Compatibility 89/336
The specifications published in this manual are not binding, and may be revised or updated at
any time by Clay Paky without notice in the interests of improving product quality.
11
12