Clay Paky ALPHA PROFILE 700 ST (C61366) - Manual (Page 22)

Lamp
Manual
Control
On
Off
Fans
Monitor
Fan Speed (RPM)
Ball.In. XXXX
Eff.In XXXX
Lamp XXXX
Blades XXXX
Board
Diagnost.
Dmx
Monitor
Board Status Err%
0:PT-3f Good 0.00
1:6-Ch Good 0.00
2:6-Ch Good 0.00
3:6-Ch Good 0.00
4:6-Ch Good 0.00
Network
params
System
Version Board Revis. Hw.rv.
CPU brd x.x.x x.x
com.dev x.x
0: PT-3f x.x x.x
1: 6-Ch x.x x.x
2: 6-Ch x.x x.x
3: 6-Ch x.x x.x
4: 6-Ch x.x x.x
Sensor
Status
22 ALPHA PROFILE 700 & “ ST ”
LAMP STRIKES
Used for displaying the number of times the lamp was turned on (total and
partial).
1) Press
F - the number of times the lamp was turned on (total and
partial) appears on the display.
Total counter
Counts the number of times the lamp was turned on (from
manufacture to date).
Partial counter
Counts the number of times the lamp was turned on since the last
reset to date.
2) Press F to reset partial lamp strikes hours, a confirmation message
(Are you sure ?) appears on the display.
3) Select YES to reset partial counter or NO to keep the current setting
and return to the top menu level
SISTEM VERSION
Used for displaying the software and hardware version of each board
installed in the projector.
CPU brd (CPU board)
0: PT-3f (Pan / Tilt board)
1: 6-Ch (6 channel board)
2: 6-Ch (6 channel board)
3: 6-Ch (6 channel board)
4: 6-Ch (6 channel board)
BOARD DIAGNOSTIC
Used for displaying the status error of each board installed in the projector:
0: PT-3f (Pan / Tilt board)
1: 6-Ch (6 channel board)
2: 6-Ch (6 channel board)
3: 6-Ch (6 channel board)
4: 6-Ch (6 channel board)
DMX MONITOR
Used for displaying the projector DMX channel level in bit (Val) and in
percentage (Perc).
FANS MONITOR
Used for displaying the speed of each fan installed in the projector:
Ball. IN (Ballast IN Fan)
Eff.IN (Effects IN Fan)
Lamp (Lamp Fan)
Blades (Blades fan)
SENSOR STATUS
It lets you check the correct operations of each "sensor” installed in the
projector, each channel is associated with one of the following three
parameters:
• n.a.= sensor not available
• ON= sensor working
• OFF= sensor defective
NETWORK PARAMS
Allows the "Network" parameters of the projector to be displayed or:
IP address: Internet Protocol address (two projectors must not have
the same IP address)
IP mask: 255.0.0.0
Mac address: Media Access Control: the projector’s Ethernet Address.
Lamp
Strikes
Total XXX
Partial XXX
Reset...
Information
LAMP
Used for turning lamp on and off from the projector control panel.
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to turn the lamp on (On) or off (Off)
3) Press F to confirm the selection or LEFT D to keep current settings
and return to the top level.
MANUAL CONTROL