Decimator Design 3G-TPG - Manual (Page 6)

3G-TPG OPERATING MANUAL
www.decimator.com
Copyright © 2009 DECIMATOR DESIGN PTY LTD
6
AUDIO: (Has SUB‐MENUs)
When highlighted in the Menu Window, press the ENTER button to enter this sub‐menu.
Press the < and > buttons to move left or right respectively through the six menus below and
press the BACK button to go back to the Main Menu when finished.
1. AUDIO/Selected Pair (Parameter)
This is the currently selected stereo audio pair.
When highlighted in the Menu Window, the Selected Pair is displayed in the Parameter
Window.
Press the ENTER button to toggle through the following pairs:
a) Group 1, Pair 1
b) Group 1, Pair 2
c) Group 2, Pair 1
d) Group 2, Pair 2
e) Group 3, Pair 1
f) Group 3, Pair 2
g) Group 4, Pair 1
h) Group 4, Pair 2
2. AUDIO/Enable (Parameter)
This enables the tone generator for the current pair.
When highlighted in the Menu Window, the Enable status will be displayed in the Parameter
Window.
Press the ENTER button to toggle the ON/OFF status of the currently selected pair.
3. AUDIO/Frequency (Has SUB‐MENU with parameter)
This is the audio tone frequency in Hz (cycles per second) for the currently selected pair.
When selected in the Menu Window, the Frequency is displayed in the Parameter Window.
When highlighted in the Menu Window, press the ENTER button to enter this sub‐menu.
The frequency can then be decreased using the < BUTTON or increased using the > BUTTON,
in the inclusive range of 1 to 20,000Hz in Frequency Steps.
Press the BACK button to leave this SUB‐MENU.
4. AUDIO/Frequency Step (Parameter)
This is the amount the frequency is increased or decreased by, when using the previous
menu.
When highlighted in the Menu Window, the Frequency Step will be displayed in the
Parameter Window.
Press the ENTER button to toggle between Frequency Steps of 1Hz, 10Hz, 100Hz and
1000Hz.
5. AUDIO/Amplitude (Has SUB‐MENU with parameter)
This is the tone amplitude for the currently selected pair.
When selected in the Menu Window, the Amplitude in dBFS is displayed in the Parameter
Window.
When highlighted, press the ENTER button to enter this sub‐menu. The frequency can then
be increased using the < BUTTON or decreased using the > BUTTON, in the inclusive range of
0dBFS to ‐100dBFS in steps of 1dBFS.
Press the BACK button to leave this SUB‐MENU.