Boulder Amplifiers 860 - Manual (Page 16)

4-2
SETTING BOULDERLINK SWITCHES
Every Boulderlink system must have one “MASTER” component,
and only one component can be set to MASTER. This is usually
the preamplifier. Power amplifiers and other products not having a
MASTER/SLAVE switch are not eligible to be “MASTER.”
SETTING BOULDERLINK ID NUMBERS
Every component is required to have a unique Boulderlink ID
number.
Each Boulder 860 Stereo Power Amplifier has a thumbwheel switch
on the rear panel. Start by setting the switch on the first amplifier to 0
or 1 and then increment up from there without any duplication. Use of
the lowest numbers will speed up turn-on as each amplifier is allowed
about three seconds before the next. This spreads out the power line
inrush currents thus preventing house circuit breakers from unnecessary
tripping. Up to 16 power amplifiers may be connected together in one
Boulderlink cable daisy chain.
BOULDER
LINK