DJI P330CB-H3-2D - Manual

©2013 DJI Innovations. All Rights Reserved. 1|
P330CB-H3-2D Instruction V1.00
P330CB-H3-2D Board is designed to replace the center board inside the PHANTOM. P330CB-H3-2D has
integrated PMU(Power manage unit) and GCU(Gimbal control unit)
，and has added ports for wireless video
transmission module and Zenmuse H3-2D to enhance the compatibility with H3-2D.
For NAZA-M Firmware version V3.12 or above
，Assistant software version V2.12 or above.
Introduction
To battery
Note: only
3S battery
is allowed
GPS port, Connect
GPS module with
GPS cable
To X3 port on MC
To EXP port on MC
Installation
position for MC
Reserved
Connect to
wireless video
transmitter with a
3pin cable
Connect to 8pin
port on H3-2D
Gimbal with an
8pin cable
wireless
video
transmitter
Signal
VCC
GND
In the box
P330CB-H3-2D Board(1), LED Board(1), 8pin cable(1), 3pin cable(1), 3M Fixing pad(1)
Spare screws: Phillips-head screws M2.0*6.5(5) and M1.6*4(3)
Self-prepared tools
Allen screw driver, Phillips-head screw driver, soldering iron, cable ties, scissors
Assembly steps
1 、Disassemble the 4 propellers of the PHANTOM.（Disassemble 4 prop guards too if they are assembled）
2 、Remove screws on 4 arms to open the top cover of PHANTOM. Below shows the positions of screws to be
removed on one arm.
Fig.1 Screws to be removed