DJI P330CB-H3-2D - Manual (Page 3)

©2013 DJI Innovations. All Rights Reserved. 3|
4 、Disassemble the original LED Board, assemble the new LED Board
LED Shell Screws
LED
Board
Fig.4 Replace the LED Board
5 、Assemble P330CB-H3-2D
（1）Remove the MC from the original center board and assemble the MC on P330CB-H3-2D Board with 3M
fixing pad, make sure the MC is assembled in the direction shown below.
（2）Assemble the P330CB-H3-2D Board with screws(D1-D4).
（3）Solder the ESC cables to the P330CB-H3-2D Board as VCC to V and GND to G.
（4）Connect the cables to the MC then tidy and check the final connections.
C3 C3
C2 C2
C1 C1
C4 C4
D3 D3
D2 D2 D1 D1
D4 D4
Fig.5 Assemble and solder