DJI iOSD MARK II - Manual (Page 3)

©2012-2013 DJI Innovations. All Rights Reserved.
3
Introduction
DJI iOSD is specially designed for DJI autopilot system during the FPV flight or other aero-modeling activates. DJI iOSD
can transmit video and iOSD information in real time, which will help you to obtain the aircraft status information during a
FPV flight. It can display power voltage, flight velocity, height, distance from the home point, horizontal attitude, GPS
satellite number, etc. iOSD and video information are superposed on the receiver, making iOSD data clearly visible and
bringing you a more involved flight experience.
DJI iOSD should be used in conjunction with a DJI autopilot system. It supports two video input sources under PAL or
NTSC mode, which can be selected remotely by an R/C transmitter switch. The R/C TX switch can also change the
wireless video transmitter channel remotely when user uses the wireless video transmitter specified by DJI. The iOSD
supports online upgrades. The iOSD has built-in BEC, which is on one hand for the power supply of the camera, on the
other hand for the power supply of the autopilot system’s main controller to improve the power supply reliability of the
main controller.
Specified autopilot systems for the iOSD
Status Autopilot system & Aircraft
Supported A2, WKM, NAZA-M*, NAZA-M V2*, PHANTOM 2
Not yet supported WKH 、ACE ONE、ACE WAYPOINT
*iOSD should be connected to the NAZA-M or NAZA-M V2 via the PMU V2 (NAZA-M V2 Accessory).
*iOSD should not be connected to the WKM and NAZA-M/ NAZA-M V2 at the same time.
*NAZA-M should be upgrade to the firmware version of V3.16 (or above), with the same assistant software V2.16 of
Naza-M V2.