DJI iOSD MARK II - Manual (Page 4)

©2012-2013 DJI Innovations. All Rights Reserved.
4
In the Box
iOSD Controller ×1
Connect the iOSD controller to your DJI autopilot system via
CAN-Bus Cable. It communicates with the main controller,
receives data from the main controller, superimposes the data
with the video image, and then transmits the whole information
via a transmitter.
CAN-Bus Cable ×2
Connect the iOSD to your autopilot system through a CAN-Bus
cable.
dJ
I dJ
I
d
JI
d
JI
Video Input Cable ×1
Connect the iOSD with video input source (i.e. camera or DJI
Z15) for video input and power supply, with maximum current
of 1A. If you connect the iOSD to DJI Z15, please use the 4Pin-
Audio Head cable.
If connect to other camera, use the 4Pin cable for the
connection in accordance with the wiring diagram.
Video Output Cable ×2
Only when you use the wireless video transmitter module
specified by DJI, you can use the bi-port cable to connect the
iOSD with the video transmitter module. Otherwise, you can
use the one-port cable for your own connection in accordance
with the wiring diagram.
2-PIN to 3-PIN Cable ×1
Connect the iOSD with the R/C receiver through this cable.
When there are two video signal inputs, it is used for the
selection of video signal sources. It can be used for the
selection of AVL58 video channel.