3 connecting the 803 ti stand, Connecting the 803 ti stand, Figure 3 – Metrohm 803 Ti Stand User Manual
Page 18
3.3 Connecting the 803 Ti Stand
■■■■■■■■■■■■■■■■■■■■■■
10
■■■■■■■■
803 Ti Stand
4 Press the holding bracket downwards in order to fix the titration ves-
sel. The levers of the holding bracket must enclose the pins of the
plastic ring on the titration vessel in order to ensure a secure hold.
5 Adjust the height of the KF titration cell by pressing the locking lever.
It should almost touch the surface of the stirrer. The position can
now be fixed by readjusting the clamping ring.
Once the height of the KF titration cell has been adjusted correctly,
the entire cell can be raised and swiveled to the right as required by
pressing the locking lever.
3.3
Connecting the 803 Ti Stand
Connect the titration stand as follows:
1 Exit the control software.
2 Connect the connection cable of the titration stand to one of the
sockets marked with MSB on the rear of the control device.
MSB
Waste
Solvent
Figure 3
Connecting the 803 Ti Stand
3 Connecting an additional device (e.g. Dosimat or Dosino) to the MSB
connector of the titration stand (optional).