Banner EZ-SCREEN­ Safety Light Curtain Systems - Manual (Page 4)

About This Document
Important . . . Read This Before Proceeding!
It is the responsibility of the machine designer, controls engineer, machine builder and/or maintenance electrician to apply and maintain
this product in full compliance with all applicable regulations and standards. The product can provide the required safeguarding function
only if it is properly installed, properly operated, and properly maintained. This manual attempts to provide complete installation, opera-
tional, and maintenance instruction. Reading the manual completely is highly recommended. Please direct any questions regarding the
application or use of the product to the Banner Engineering Applications at the locations listed here.
For more information regarding U.S. and international institutions that provide safeguarding application and safeguarding product per-
formance standards, see the following sections.
WARNING: User Responsibility
The user is responsible to:
• Carefully read, understand and follow the information in all documentation for this product.
• Perform a risk assessment of the specific machine guarding application.
• Determine what safeguarding devices and methods are appropriate per the requirements defined in
EN ISO 13849-1 and other appropriate standards.
• Create and confirm each configuration and then verify that the entire safeguarding system (including
input devices and output devices) is operational and working as intended.
• Periodically re-verify as needed, that the entire safeguarding system is working as intended.
Failure to follow any of these recommendations can potentially create a dangerous condition that
may lead to serious injury or death.
Use of Warnings and Cautions
This manual contains numerous WARNING and CAUTION statements:
• Warnings refer to situations that could lead to significant or serious personal injury or death.
• Cautions refer to situations that could lead to slight personal injury or potential damage to equipment.
Warnings are intended to remind the machine designer, control engineer, machine builder, maintenance electrician, or end user how to
avoid misapplication of this product and effectively apply the EZ-SCREEN Type 2 to meet the various safeguarding application require-
ments. You must read and abide by the warnings.
EC Declaration of Conformity (DOC)
Banner Engineering Corp. herewith declares that the EZ-SCREEN Type 2 Light Screen is in conformity with the provisons of the Machi-
nery Directive (Directive 2006/42/EC) and all essential health and safety requirements have been met. For more information, visit
www.bannerengineering.com/EZSCREEN .
EZ-SCREEN® Type 2 Light Screen Instruction Manual
4 www.bannerengineering.com - tel: 763-544-3164 122452 rev. B