Banner PresencePLUS Pro—PRO Camera - Manual (Page 16)

01/04
Hardware Installation PresencePLUS ® Pro
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
10
P/N 68368 rev. B 01/04
Mounting the Camera
Use only Banner Camera Model PPCAM with the controller. For dimension details, see Camera Dimensions on
page 30.
Mount the camera to a Banner camera mounting bracket or to a flat surface. The camera has six M3 threads (two
on the top and two on each side) and one 1/4–20 UNC thread on its base.
Cable Bend Relief
If using a straight cable, allow at least 75 mm (3
"
) clearance at the rear of the camera for cable bend relief. If using
a right-angle cable, allow at least 50 mm (2
"
).
Mounting Hardware
The following mounting hardware is supplied with all brackets:
• Four M3 x 0.5 x 6 mm socket head cap screws
• Four medium split lock washers
• Four flat washers
• Short-arm hex key wrench
------------------------------------------------------
Camera Mounting Brackets
Mount the camera with a U-Bracket, Long U-Bracket, Right-Angle Bracket, or Knuckle Assembly Kit. Secure the
camera to the bracket with the supplied M3 screws.
These mounting brackets can be ordered from Banner. See Mounting Brackets on page 35.
For dimension details, see Camera Mounting Bracket Dimensions on page 31.
Camera Mounting Knuckle Assembly Kits SMBPPK3 and SMBPPK6
----------------------------------------------------------------------------------------
Kit Model SMBPPK3 with 76 mm (3") extension
Kit Model SMBPPK6 with 152 mm (6") extension
3-inch or 6-inch Extension