Banner Safety Mat Monitoring Modules - Manual

SM-GA-5A (12-24V dc / 115V ac operation) and SM-HA-5A (12-24V dc / 230V ac operation)
• Monitors one 4-wire safety mat, or multiple mats in series
• Selectable Automatic (Auto) Reset or Monitored Manual Reset
• Input monitoring circuit incorporates redundant microproces-
sors
• Plug-in terminal blocks
• Four normally open output switching channels for connection
to control-reliable power interrupt circuits and one normally
closed auxiliary output channel for status monitoring
• Two auxiliary solid-state outputs indicate state of internal re-
lays K1 and K2, and state of system (ON = normal operation)
• 6 amp safety output contacts; 5 amp aux. output contacts
• DIN-rail-mountable 45 mm-wide housing
• External device monitoring (one-channel EDM)
• Design complies with UL 991, ISO 13856-1, ISO 13849-1 (EN
954-1) Category 4: Internal Module, or Category 3 with 4-wire
Safety Mat connected (see Overview)
Model Supply Voltage Outputs Output Rating
SM-GA-5A 12-24V dc or 115V ac 4 Normally Open Safety
1 Normally Closed Aux.
2 Solid-State Aux. N.O. Safety Outputs: 6 A
N. C. Aux. Outputs: 5 A
SS Aux Outputs: 100 mA
SM-HA-5A 12-24V dc or 230V ac
WARNING: Not a Stand-Alone Safeguarding Device
This Banner product is not a stand-alone point-of-operation guarding device, as defined by OSHA
regulations. It is necessary to install point-of-operation guarding devices, such as safety light screens
and/or hard guards, to protect personnel from hazardous machinery. Failure to install point-of-operation
guards on hazardous machinery can result in a dangerous condition which could lead to serious
injury or death.
SM-xA-5A Safety Mat Monitoring Modules
P/N 122364_Web
rev. C 8/17/2012