Buffalo Technology Buffalo AirStation WLI3-TX1-G54 - Manual (Page 16)

16
Network Settings - This page contains the network IP Address
settings of the Ethernet Converter
◗
Automatic IP Assignment - This setting specifi es the
Ethernet Converter to obtain its IP Address from a DHCP
server on the network. Consult with your network admin-
istrator regarding whether this device should obtain its IP
Address from a DHCP Server.
◗
Manual Assignment - This setting specifi es the Ethernet Converter to operate on a specifi c
IP Address. This is often referred to as a Static IP Address. If a manual assignment is pre-
ferred, then you will be required to enter an appropriate IP Address and Subnet Mask for the
Ethernet Converter.
■ NOTE: The IP Address is required for confi guring the Ethernet Converter. Be careful
when changing its address, as it may cause undesired operation. Also, please document any
changes and update any browser bookmarks that may be referencing the Ethernet Converter
Web Based Confi guration.
◗
The Ethernet Converter Manager may be used to set the IP Address in the event of changing
the IP Address inappropriately.
◗
The IP Address does not need to be in the range of the DHCP server's scope to successfully
pass DHCP requests to the network client behind the Ethernet Converter.