Buffalo Technology Buffalo AirStation WLI3-TX1-G54 - Manual (Page 4)

4
If you have a Windows 98/ME/2000/XP machine with a CD-ROM drive available on your com-
puter network, it is recommended to use the Ethernet Converter Manager to confi gure the Eth-
ernet Converter. The following steps will guide you through confi guring the Ethernet Converter
via the Ethernet Converter Manager.
◗
With the included network patch cable, plug the Ethernet Converter's LAN port into an
open port on your network's router, or on one of your network switches or hubs. If there are
no ports available, you can temporarily remove a computer or other connected device and
plug the Ethernet Converter to that port. You can plug the Ethernet Converter directly to the
confi guring computer, but will have to use the manual confi guration found on 'Page 8' of this
Manual.
◗
Once the network cable has been plugged in, plug the Ethernet Converter's AC Adapter into
an available power outlet. Then attach the power connector to the back of the Ethernet
Converter. The boot up process takes 30 seconds and can be confi rmed completed
when both the Wireless and Ethernet lights are green.
◗
Return to the PC designated for confi guration and
insert the included Ethernet Converter CD-ROM into the PC's CD-ROM
drive.
◗
The AirNavigator application should launch
automatically. If it does not, browse your CD-ROM
drive in Windows and run the launch.exe program.
Confi guration with Ethernet Converter Manager