Hinkley Lighting HADLEY 3305BR-LED - Manual

assembly instructions
Family: Hadley Item No. 3305
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1. Prior to installing glass, fixture should be lamped.
2. To install glass (2), lay glass into ring (3) - see Drawing 1.
3. Slip the 4 holes (H) of ring over the threaded studs (G) of the uprights (UP) and hold
in position.
4. Thread decorative knobs (4) onto end of studs (G) and tighten to secure glass.
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
hanging the fixture from the ceiling, and then installing the glass.
start here
3305
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Glass Installation
01.01.13
2
3
4 H
UP
G
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
1. Fixture main body can be installled prior to lamping and installing the glass.
2. Please follow instruction sheet (IS19-92) for hanging instructions and follow
instruction sheet (IS-18) to make all electrical connections.