Hinkley Lighting HADLEY 3305BR-LED - Manual (Page 2)

H I N K L E Y L I G H T I N G 33000Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
1. Shut off electrical current before starting. If the fixture you are replacing is
turned on and off by a wall switch, simply turn the switch off. If not, remove
the appropriate fuse (or open the circut breakers) until the fixture is dead.
• DO NOT restore current - either by fuse, breaker or switch - until the new
fixture is completely wired and in place.
1. Determine the desired height the chandelier will be installed.
2. The fixture is supplied with assorted stems sizes. Determine what combination of
stems are needed to achieve desired length - see Drawing 1.
3. Slip stems over wire and thread first stem into coupler on top of chandelier, longest
stem first. Repeat this process until all required stems are threaded together.
4. Slip wire through center of canopy swivel and thread onto stem assembly.
start here
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Fixture Assembly
Drawing 2 - Fixture Assembly
I.S.19-92
hanging instructions
I.S
. 19-92
stem
wire
wire
wire
stem
3
2223
4
2
1
5
supply wire
1. Thread two long 8-32 screws (1) into the mounting strap (2).
NOTE: The two screws should be threaded into the holes that line up with the
holes in the canopy (3) - see Drawing 2.
2. Attach the mounting strap (2) to the junction box with two 8-32 screws (5).
3. Make wire connections following the instructions on (I.S. 18) instruction sheet
provided.
4. Assistance is recommmended for the follow process.
5. Lift asssembled fixture with stems and canopy up to ceiling and slip screws (1)
through holes in canopy (3). Secure fixture to mounting strap by threading balls
knobs (4) onto end of screws (1) and tighten.
01.01.13