BellSouth PID99 - Manual (Page 13)

2 2
M e s s a g e Wa i t i n g I n d i c a t o r L i g h t d o e s n o t f l a s h a n d
M E S S A G E WA I T I N G d o e s n o t a p p e a r.
• Make sure either Stutter Dial Tone or Visual Message Waiting
Indication is offered by BellSouth and that it has been turned on.
L I N E E R R O R m e s s a g e i s d i s p l a y e d .
• LINE ERROR appears on the display if the phone detects anything other
than valid Caller ID information during the silent period after the first
ring. If the telephone is answered between the first and second ring,
the Caller ID information may not be received properly.
• LINE ERROR may indicate the presence of noise or static on your
telephone line. If this condition persists, call the BellSouth service
center.
C a l l e r I D i n f o r m a t i o n s t o re d i n m e m o r y i s d e l e t e d
• The Caller ID information showing on the display will be erased when
the DELETE button is pressed.
• All Caller ID information stored in memory will be lost when the
batteries run down.
M A I N T E N A N C E
Clean the outside of the phone with a soft damp cloth. Do not use any
type of abrasive pad, scouring powder or solvent such as alcohol or benzene
as they may damage the finish of the phone cabinet.
H E A R I N G A I D C O M P A T I B I L I T Y
The PID99 is compatible with inductively coupled hearing aids.
2 3
F C C I N F O R M A T I O N
This product is registered with the Federal Communications Commission
and is in compliance with parts 15 and 68, FCC Rules and Regulations.
To comply with FCC regulations, the following conditions must be met:
T h i s d e v i c e c o m p l i e s w i t h P a r t 6 8 o f t h e F C C r u l e s .
The label on the bottom of this device contains the FCC registration number
and ringer equivalence number.
If requested by the telephone company, the FCC registration number of
this device and the ringer equivalence number must be reported. USOC
jack RJ11. For reliable operation, the sum of the ringer equivalence numbers
for devices connected to a single telephone line should not exceed five.
This device must not be installed on coin operated telephone lines or
party lines.
R i g h t s o f t h e Te l e p h o n e C o m p a n y
Should your equipment cause trouble on your line which may harm the
telephone network, the telephone company shall, where practicable, notify
you that temporary discontinuance of service may be required. Where prior
notice is not practicable and the circumstances warrant such action, the
telephone company may temporarily discontinue service immediately. In
case of such temporary discontinuance, the telephone company must: (1)
promptly notify you of such temporary discontinuance, (2) afford you the
opportunity to correct the situation and (3) inform you of your right to
bring a compliant to the Commission pursuant to procedures set forth in
Subpart E of Part 68, FCC Rules and Regulations.
The telephone company may make changes in its communications facilities,
equipment, operations of procedures where such action is required in the
operation of its business and not inconsistent with FCC Rules and
Regulations. If these changes are expected to affect the use or performance
of your telephone equipment, the telephone company must give you
adequate notice, in writing, to allow you to maintain uninterrupted service.
T h i s d e v i c e c o m p l i e s w i t h P a r t 1 5 o f t h e F C C r u l e s .
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Repair work on this device must be done by Consumerware, Inc.
or an authorized repair station.