Hinkley Lighting MERIDIAN 3876SK - Manual (Page 2)

I.S. 19-50C
hanging instructions
I.S
. 19-50C
Hanging instructions for 3 tier fixture under 50 lbs.
start here Drawing 1 - Fixture Assembly
Drawing 2 - Installation Example
A
B
C
F
D
E
L
M
top center
knockout 3/8 steel pipe
J
K
wire
ceiling
joist
ground
wire
from fixture
ceiling
joist
support
block junction
box
bridge
supply wire
hex nut
3/8 steel pipe
1. Shut off electrical current before starting. If the fixture you are replacing is
turned on and off by a wall switch, simply turn the switch off. If not, remove
the appropriate fuse (or open the circut breakers) until the fixture is dead.
• DO NOT RESTORE CURRENT - EITHER BY FUSE, BREAKER, OR SWITCH -
UNTIL THE NEW FIXTURE IS COMPLETELY WIRED AND IN PLACE.
2. Supply wires shall enter the outlet box (A) through any knockout EXCEPT
the top center knockout - see Drawing 1.
1. Fixture is to be mounted by a 3/8 steel pipe with 3/8 -18 NPSM thread, 3/4”
threads at both ends (not supplied). Pipe should be anchored to structure or
bridging member with sufficient strength to support 4 times the fixtures
weight - see Drawing 2.
2. Adjust pipe so 1/2” of 3/8 steel pipe extends into the junction box, at the
center knock out.
1. Thread pipe coupler (B) onto protruding pipe inside outlet box. Secure in place by
tightening allen head screw (C) - see Drawing 1.
2. Thread hexnut (D) onto threaded nipple (E). Thread nipple (E) into coupler (B).
Secure in place by tightening hexnut (D) against coupler (B) and then tightening
allen screw (F).
3. Thread hexnut (J) onto nipple (E). DO NOT tighten hexnuts (J) at this time.
4. Thread screw collar loop (K). Adjust loop height so the half of the exterior thread
on screw collar loop (K) is exposed when canopy (L) is held up to the ceiling.
1. Determine length of chain you will require. Attach one end of length of chain to fixture.
2. Slip threaded ring (M) and canopy (L) onto chain - see Drawing 1.
3. Attach fixture with chain to screw collar loop (K
). Please get assistance, weight and
size of fixture is difficult to manage alone.
4. Weave ground wire, and supply wire, through chain, up through center
of screw collar loop (K), through center of nipple (E), and out the opening on the side
of coupler (B).
ground
wire
5. Make electrical connections from supply wire to fixture lead wires. Refer to instruc-
tion sheet (I.S. 18) and follow all instructions to make all necessary wiring connections
6. After connections are made slip wires into junction box. Slip canopy along chain and
up to ceiling. Thread thread ring (M) onto loop and tighten to secure canopy to
ceiling.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com