Hinkley Lighting CARLTON 4779SL - Manual (Page 3)

safety cable installation
WARNING: TO AVOID ELECTRICAL SHOCK, THIS SECTION OF THE INSTRUCTION
SHEET IS FOR THE SOLE PURPOSE OF SAFETY CABLE INSTALLATION, AND IS NOT
TO BE USED TO MAKE ANY ELECTRICAL CONNECTIONS.
• The safety cable must be attached to a ceiling joist or other permanent structure
independent of the junction box
1. Using a 1/8” dia., drill a pilot hole (1). It must be drilled into the permanent structure
or through the junction box on joist side were the safety cable is to be attached - see
Drawing 3.
2. Insert and thread a 1/4” hex head lag screw (2) (not included) into pilot hole.
3. Continue back to previous I.S 19-50 to continue installation of this fixture.
4. Wrap safety cable (3) around hex head lag screw (2) and tighten to secure cable - see
Drawing 3.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Drawing 3 - Safety Cable Installatio n
junction
box
3
1
2
ceiling
joist
I.S
. 19-50
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com