BOXLIGHT CP-324i - Manual (Page 4)

4
Part names
Lens (16)
Lens cover (16)
(Slide door)
Filter cover (40)
(Air filter and intake vent
are inside.)
Elevator button (8)
Elevator foot (8)
Remote sensor (15)
Zoom knob (18)
Focus ring (18)
Vent (6)
AC inlet (13)
Power switch (16)
Elevator button (8)
COMPONENT
VIDEO ports (12)
Y
C
B
/P
B
C
R
/P
R
S-VIDEO port (12)
VIDEO port (12)
CONTROL port (11)
Part names
Projector
Lamp cover
(Lamp unit is inside.)
(38)
Elevator foot (8)
Bottom side
Speaker (6)
Front-Right side
Rear-Left side
Control buttons
(See the following page.)
(5)
Ports
(See below.)
Vent (6)
AUDIO OUT port (11)
Ports
AUDIO IN1 port (11)
AUDIO IN2 port (11)
USB port (11)
Restart switch (*) (46)
RGB IN1 port (11)
RGB IN2 port (11)
RGB OUT port (11)
Kensington lock slot
NOTE (*) About Restart switch: This Projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
Y
VIDEO
AUDIO IN1
RGB IN1
CONTROL
RGB IN2 RGB OUT
AUDIO IN2
AUDIO OUT
USB
S-VIDEO
COMPONENT VIDEO
CB/PB
CR/PR