BKI Heated Display Merchandisers CSWG - Manual (Page 12)

Hot Food Deli Case Installation
10
1. Level the case using the leg levelers at the corners of the case (Figure 1).
2. Raise the low end of the case to level it, do not lower the high end.
3. Check for level side-to-side and front-to-back.
4. If you are installing adjoining cases, position the next case in line beside the level case and
proceed to the next step.
5. Level this case in the same manner.
6. When level, bolt the two cases together at the locations shown in Figure 1.
NOTE: None of the end components shown in Figure 2 should be attached to adjoining case
ends
If the cases have been properly leveled, the front panels and counter tops should align with a
small, uniform gap between the front panels of the two cases.
7. Proceed in the same manner until all the cases in the line are level and bolted together.
8. Complete the line up by slipping the Counter Top Joint Cover over the end flanges of the
adjoining counter tops.
Kick Plate Mounting
A black vinyl-covered kick plate is provided for the front and back of each case.
1. Slide the front kick plate (the wider of the two) behind the lower finished front panel of the case
(see Figure 2).
2. Make certain that the ends of the kick plate are flush with the ends of the lower finished front
panel and that the kick plate is flush to the floor.
3. Drill 5/32” diameter holes in the case base to match the pre-drilled holes in the kick plate.
4. Attach the kick plate to the case base with the black sheet metal screws provided.
5. Mount the back kick plate to the case in the same manner.
6. Place the End Kick Plates in position (see Figure 2).
NOTE: There are left and right hand parts. The longer end flange faces toward the front of the case
with the black side out. The End Kick Plates fit over the ends of the front and back kick plates and
flush to the floor.