BKI Heated Display Merchandisers CSWG - Manual (Page 8)

Hot Food Deli Case Operation
6
Software Controls - Default Screen
The Default Screen appears on the touchscreen during normal
operation. The screen shows the menu button and a
representive temperature.
The representative temperature does not correspond to the
internal temperature of the food products in the case. This
temperature is only an indication that the case is operating
properly and heating.
When the unit is first powered up the representative temperature
will be approximately room temperature. As the unit preheats the
representative temperature will rise. The representative
temperature will stabilize when the unit reaches operating
temperature.
The representative temperature should be approximately the
same from day to day when the unit is in operation. A significant
change in this temperature without changing any of the
temperature settings of the unit may indicate a problem with the
unit. A qualified BKI service representative should be contacted.
Default Screen
Software Controls - Viewing Settings
The current heater settings can be viewed by touching the Menu
Button [M] on the Default Screen. The Menu Screen will then be
displayed.
To view the current settings for either Well Temp or Upper Heater
touch the appropriate button on the Menu Screen. The View
Setting Screen for the selected heaters will be displayed.
To return to the Default Screen, touch the Exit Button [X].
If the controller is configured to control each well position
independently the View Setting Screen as shown at right will be
displayed. Use the left and right arrows to display the heater
setting for the various well positions of the unit. The progress bar
gives a visual representation of the well location for which the
setting is being displayed.
The current heater setting is displayed on the right side of the
screen. The setting is a numeric value between 1 and 10 where
10 is the hottest setting.
If the controller is configured to control all of the well positions at
the same setting, the progress bar will be solid and the left and
right arrows will not be displayed. The setting shown will be for
the heaters at all of the well positions.
To return to the Menu Screen, touch the Menu Button [M]. To
return to the Default Screen, touch the Exit Button [X].
Touching [Set Clock] on the Menu Screen will display the time
and date. To return to the Menu Screen, touch the Menu Button
[M]. To return to the Default Screen, touch the Exit Button [X].
Menu Screen
Well Heater 1
X M
View Setting Screen
Lower Right
Lower Left
Menu Button
Exit Button
Progress Bar
Current Setting