E-flite T-34 Mentor 25e ARF - Manual (Page 15)

15 E-flite T-34 Mentor 25e ARF Assembly Manual
 3. Tie the string located inside the wing to the end
of the servo lead. Pull the servo lead through the
wing and out the hole in the top sheeting.
 4. Use a pin vise and 1/16-inch (1.5mm) drill
bit to drill the four holes for the servo mounting
screws.
 5. Use 2–3 drops of thin CA to harden the holes
drilled in the previous step.
 6. Use the screws provided with the servo and a #1
Phillips screwdriver to secure the servo in the wing.
Make sure the output of the servo faces the aileron
when installed.
 7. Thread the nylon control horn on the aileron
control screw. Thread the horn on so the top of the
horn is flush with the end of the screw as shown.
You may need to use a #1 Phillips screwdriver to
hold the control horn screw while threading on the
nylon control horn.
 8. Use a pushrod keeper to secure the 3 1 /
2
-inch
(89mm) aileron linkage wire to the nylon control
horn. The wire is inserted from the side of the horn
closest to the wing tip.