E-flite T-34 Mentor 25e ARF - Manual (Page 19)

19 E-flite T-34 Mentor 25e ARF Assembly Manual
 9. Use the flap adjustment of your radio system to
set the FULL FLAP position. The measurement for
full flap is 1/2-inch (13mm).
 10. Use the flap adjustment of your radio system to
set the UP FLAP position. The flaps will align with
the trailing edge of the wing when up.
We have shown three positions for the flaps. If you
are using a transmitter with only a 2-position switch,
then the half flap position would not be used. Flap
throws are covered at the end of the manual.
Joining the Wing Panels
Required Parts
Wing panel (right and left)
Nylon control horn Nylon strap
Aluminum wing tube
3mm x 12mm self-tapping screw (2)
Aluminum pin, 5/32 x 1
3 /
16
-inch (4mm x 30mm)
Required Tools and Adhesives
Thin CA Phillips screwdriver: #1
 1. Thread the control horn on the flap linkage of
the right wing. The top of the horn will be flush with
the top of the threads as shown.
 2. Slide the aluminum wing tube into the wing
panel. Slide the tube in only as far as it will easily
slide. Do not force the wing tube into the socket.
 3. Slide the 5/32 x 1 3 /
16
-inch (4mm x 30mm)
aluminum pin in the wing panel in the socket near
the trailing edge of the wing as shown.
 4. Slide the wing panels together. They will fit
tightly together as shown in the second photo.