E-flite Pitts Model 12 15e ARF - Manual (Page 26)

26 E-flite Pitts Model 12 15e ARF Assembly Manual
 17. Pull the servo lead through the wing using the string.
Use tape to keep the lead from falling back into the wing.
 18. Use a drill and 1/16-inch (1.5mm) drill to drill a
hole at each of the corners of the servo cover and into
the supports. Use four 2mm x 6mm sheet metal screws to
secure the servo cover to the wing.
 19. Use a 3 3 /
4
-inch (95mm) pushrod wire, clevis and
pushrod rod wire clip to assemble and install the linkage
between the servo and control horn. Position the control
horn on the aileron so the linkage is perpendicular to the
hinge line. You will need to install the control horn on the
aileron before installing the linkage.