Belkin F5D7634-4A-H - Manual (Page 14)

12
G Wireless Modem Router
sections table of contents 1 2 3 5 6 7 8 9 10
ConneCTInG and ConfIGURInG YoUR RoUTeR
4
11 brand-new setup
Follow these steps if you are not
replacing an existing modem�
If you are replacing an existing
modem, skip to the next section,
“Replacing an Existing Modem or
Modem Router”�
1 Retrieve the yellow RJ45
cable that was included
with your Router� First,
connect one end to any
yellow port labeled “to
Wired Computers” on the
back of your Router� Then,
connect the other end to the
networking port on the back
of your computer�
2 Retrieve the included gray
RJ11 phone cord� Connect
one end to the gray port
labeled “to ADSL” on the
back of your Router� Then,
connect the other end to
your ADSL connection
(either a wall jack or an
ADSL splitter)�
note: Some ADSL connections require a
micro filter� Your ADSL provider can tell you if
you need one� Belkin includes a micro filter in
regions known to use them� You may or may
not have received one in your box�
3 Plug your Router’s power
supply into the black port
labeled “Power” on the back
of your Router�
4 Wait 20 seconds for the
Router to start up� Look at
the display on the front of
the Router� Make sure the
“Power” and “LAN (1-4)”
LEDs are lit up in green�
1
3
2
2