HF scientific Online SCADA System - Manual (Page 8)

(8/02)
Rev 1.2
6
2.3.3 Serial Port
Note: skip this step for runtime versions of Lookout. The system will default
to COM 1. If another COM port is needed, contact your vendor.
The lookout Online SCADA system will be communicating with the network of
turbidimeters through one of the available RS232 COM ports. The COM port
being used (user needs to determine which port is to be used. The Online SCADA
system process files are configured to use COM1. Please contact you vendor if the
COM port to be used is other than COM1) needs to be configured as follows
(Refer to Fig. 2-4):
From the pull down menus, select Options>> Serial Ports. Make sure that the
Serial port: is set to COM 1 and that Serial connection is set to Hardwired.
Change the Receive gap: to 50. Hit the Accept button and then the Quit button.
Fig 2-4