HF scientific Micro1000 Laboratory Turbidimeter - 0-10,000 NTU - Manual (Page 24)

Rev. 3.2 18
Select the correct day by pressing either the S or T keys to change the displayed day. When you
have selected the proper day, press the key.
6.8.Setting the Time (Hours and Minutes)
After pressing the key, the Time block will be displayed and you will see the time displayed on
the upper row of the display in 24-hour format. The number flashing corresponds to the hour.
Select the correct hour by pressing either the S or T keys to change the displayed hour. When you
have selected the proper hour, press the key. After pressing the key, the Time block will
remain displayed and the second number on the upper row of the display will be flashing: this
number corresponds to minutes.
Select the correct minutes level by pressing either the S or T keys to change the displayed minutes.
When you have selected the proper minutes level, press the key.
Note: The number of seconds in the minute will be reset to zero when the key is pressed after
selecting the proper minutes level.
6.9. Exiting the setup mode
After you have pressed the key for selecting the time, the word “END” will be shown on the
lower row of the display.