Human Touch iJoy 100 Robotic Massage Chair - Manual (Page 4)

7 6
www.ijoy.com
GET READY
Unpack the box
Chair base Backrest
Your iJoy
®
-100
requires some simple assembly
(no tools required). Just attach the backrest to the
chair base, lock it into position, and you’re set to go!
2. Check the alignment
Push the backrest forward to an upright position
to ensure that the backrest pins are properly
aligned with the pin cradles and pin latches.
3. Lock the backrest in place
Pull the backrest backward until it locks into place. Tuck the flap
on the front of the backrest down behind the seat bottom. From
behind the chair, smooth the flap against the seat bottom. The
flap attaches to the seat bottom using the hook and loop strip.
4. Connect the cable
Connect the cable located on the bottom back of the
backrest to the connector on the rear left-hand leg of
the chair base.
Pillow
To remove the backrest, lean the backrest forward.
Pull the backrest release cord located on the bottom
right of the chair base. Push down on each pin latch
to release the backrest pins from the cradle. Lift the
backrest off of the chair base.
1. Align the Backrest
Bend your knees to protect your back (you may want to get
someone to help you).
2. Align the backrest pins
Align the top backrest pin on each side of the backrest
with the pin cradle on each side of the chair base.
3. Secure the backrest
Push the lower backrest pins into the pin latches on each side of
the backrest until the pin latches snap automatically into place.
Top backrest pins
Automatic pin latch
Lower backrest pins