Human Touch bodySPA - Manual (Page 6)

humantouch.com
9 9
ENGLISH
humantouch.com
8
To keep your product working and looking its best, please follow these simple care guidelines.
care and maintenance
• Your BodySpa requires no regular maintenance.
• If the Infrared Seat lamp bulb burns out, replace it with the spare bulb that came with your unit. Additional bulbs are available from Human Touch.
• If the cedar smell is too strong during the first few months of use, wiping down the unit with a damp cloth may dampen the smell.
• To clean the inside off the unit, unplug it, then wipe it clean using a damp cloth. Do not use liquid cleaners or aerosol cleaners.
• Use furniture polish to clean the outside of the unit.
• Scratches and stains can be removed using a fine-grade sandpaper; do not sand against the grain.
• When moving the BodySpa, use the recessed grips on the front and rear of the unit to lift it, then move it to the new location.
Your BodySpa comes with a thermal circuit breaker reset, located near the master power switch on the back of the unit. Should your unit
overheat, it will automatically shut down. After allowing it to cool, press the thermal circuit breaker to return the unit to normal operation.
1. Use a Phillips-head screwdriver to remove the screw on each side of the seat bench (Fig.3).
2. Slide the seat bench forward to remove it (Fig.4).
3. Remove and replace the seat lamp bulb (Fig.5).
4. Slide the seat bench back into place, pushing it firmly toward the back of the BodySpa
until the bracket screw hole lines up with the hold in the wood.
5. Replace the screw on each side of the seat bench to secure it.
To change the seat lamp bulb
Specifications*
Fig.3
Fig.4 Fig.5
Seat bench
Seat bench
Seat lamp bulb
Operating Voltage: AC110-120V, 60 Hz
Power Consumption: 730 Watts
Dimension: 43”L x 24”W x 30”H
Weight: 110 Lbs.
*Specifications are subject to change without prior notice.