IDX CW-7 - Manual (Page 17)

15
4. Selecting frequencies and power output
FREQ SELECT switch is equipped on both TX and RX. POWER MODE
switch is located on TX side only.
FREQ SELECT switch is used to select transmission and receiving
frequency.
FREQ SELECT switch must be same position on both TX and RX.
POWER MODE switch enables you to change the transmission power,
HIGH or LOW.
4.1. Available frequencies and transmission power
The table shows the available frequencies and transmission power for U.S.
region.
Channel
position frequency
(MHz)
Limitation of use
Transmission power
HIGH LOW
CH1 5190MHz Indoor
12.5mW
/Ant.
5mW/Ant.
CH2 5230MHz Indoor
CH3 5755MHz Indoor/Outdoor
20mW/Ant.
CH4 5795MHz Indoor/Outdoor
DFS AUTO
Outdoor use allowed with DFS
ON
Automatically select from
following frequencies.
5270,5310,5510,5550,5670
MHz
Indoor/Outdoor
System
initialization
(link time) will
take one minute
There is a strict regulation allowing certain frequencies for indoor use only.
Please note that uses of unauthorized frequencies outdoors may be a
violation of the law.