JK Audio Concierge 2x6 - Manual (Page 10)

14 Concierge™ 2x6 Switch Core FCC Part 15 Compliance 15
Declaration of Conformity FCC Part 15 Compliance
This device complies with Part 15, Subpart B of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Changes or modifications not expressly approved by JK Audio can void the user’s authority
to operate the equipment.
FCC Registration
Your new JK Audio product has been registered with the Federal Communications
Commission (FCC). This product complies with the standards in Part 68 of the
FCC rules.
1. Connection And Use With The Nationwide Telephone Network
The FCC requires that you connect this telephone equipment to the national telephone
network through a USOC RJ-11C modular telephone jack. This equipment may not be
used with Party Line Service or Coin Telephone Lines. This equipment is hearing aid
compatible.
2. Information For The Telephone Company
Upon request from your local telephone company, you are required to provide the
following information: a) The "line" to which you will connect the telephone equipment
(that is, your telephone number), and b) The telephone equipment's FCC registration
number. This can be found on the bottom of your telephone equipment, and, c) The
ringer equivalence number (REN) for this equipment. The REN is used to determine the
quantity of devices which will be connected to the telephone line. Excessive RENs on the
telephone line may result in the devices not ringing in response to an incoming call. In
most, but not all areas, the sum of the RENs should not exceed 5.0. To be certain of the
number of devices that may be connected to the line, as determined by the total RENs,
contact the local telephone company.
3. Repair Instructions
If it is determined that your telephone equipment is malfunctioning, the FCC requires that
it not be used and that it be unplugged from the modular outlet until the problem has been
corrected. Repairs to this telephone equipment can only be made by the manufacturer
or its authorized agents or by others who may be authorized by the FCC. For repair
procedures, follow the instructions outlined under the warranty section of the manual.
4. Rights Of The Telephone Company
If telephone equipment is causing harm to the network, the telephone company may
temporarily discontinue your telephone service. If possible, they'll notify you before they
interrupt service. If advanced notice isn't practical, you'll be notified as soon as possible.
You'll be given the opportunity to correct the problem, and you'll be informed of your
right to file a complaint with the FCC. Your telephone company may make changes in its
facilities, equipment, operations or procedures that could affect the proper functioning of
your JK Audio product. If such changes are planned, you'll be notified by your telephone
company.
FCC Part 15 Compliance Declaration of Conformity
Manufacturer’s Name
Manufacturer’s Address JK Audio, Inc.
1311 E 6
th Street
Sandwich, Illinois 60548 USA
Declares that the product:
Product Name
Model Numbers Concierge™ 2x6 Switch Core
CON2X6
Conforms to the following Product Specifications:
Safety:
AS/NZS 60950.1:2011
EN 60595-1:2006/A11:2009/A1:2010
UL Standard 60950-1 2nd edition
ESD:
EN 55024:1998
EN 61000-3-2
EN 61000-3-3
Emissions:
EN 55022:1998
AS/NZS CISPR 22 (2002)
FCC Part 15, Subpart B
ICES-003
Telecom
AS/CA S002:2011
FCC CFR 47, Part 68
TIA-968-B, TIA-1096-A
Supplementary Information:
The product herewith complies with the requirements of the following Directives and
carries the CE marking accordingly:
LVD 2006/95/EC (Safety)
R&TTE 1999/5/EC (Telecom)
EMC 89/336/EEC (EMC)
RoHS Directive 2002/95/EC
The Technical File containing supporting documentation is maintained at:
JK Audio, Inc (Corporate Headquarters)
Compliance Manager
1311 E 6th Street
Sandwich, Illinois 60548 USA
815-897-2929 phone
815-786-8502 fax