JK Audio innkeeper 1x/rx - Manual (Page 3)

14
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own
expense.
Changes or modifications not expressly approved by JK Audio can
void the user's authority to operate the equipment.
FCC Registration
Your new JK Audio product has been registered with the Federal
Communications Commission (FCC). This product complies with
the standards in Part 68 of the FCC rules.
1. Connection and use with the nationwide telephone network
The FCC requires that you connect this telephone equipment to
the national telephone network through a USOC RJ-11C
modular telephone jack.
This equipment may not be used with Party Line Service or Coin
Telephone Lines.
This equipment is hearing aid compatible.
2. Information for the telephone company
Upon request from your local telephone company, you are
required to provide the following information:
a)
The "line" to which you will connect the telephone
equipment (that is, your telephone number), and
FCC Part 15 Compliance
3
Features—Front View
1 Call Button - Takes the line off-hook - press this button to answer a
call or you can direct a call from your aux phone through the hybrid.
2 Drop Button - Press this button to drop (hang up) a call.
3 Send Level - Adjusts the signal that you are sending down the
telephone line.
4 Caller Level - Adjusts the level of the signal coming in from the
telephone line, going out the “Caller” jack.
5 Send > Mix Level - Adjust the level of your audio that will be sent to
the “Mix Out” jack.
6 Mix < Caller Level - Adjusts the level of caller audio that will be sent
to the “Mix Out” jack.
7 Headphones - The stereo headphone jack contains the signal you have
created with the Send > Mix and Mix < Caller level controls. Both left
and right channels get the same signal.
8 Mix Monitor - Adjusts the mix signal level sent to the headphone and
rear panel speaker terminals.
9 Ring LED - Flickers when you have an incoming call.
10 OH LED - Lit when you are on line with a call (off-hook).
11 Signal LEDs - Send LEDs represent the signal level going out to the
telephone line. Receive LEDs represent the signal level coming from
the phone line, after the DSP.
12 AGC - press this switch to allow the innkeeper 1x/1rx to automatically
adjust the gain of caller audio so all callers are received at an average
level..
13 Caller Ducking - press this switch to lower the caller’s audio level by
9 dB when local audio is present.
14 Presence - press this switch to boost the low end of the caller audio
signal. Presence is added to the caller audio signal only.
15 1 kHz tone generator - press switch once to send a full scale 0 dB,
maximum output level 1kHz tone down the phone line, press again to
send this signal out the Caller jack, press a third time to turn off.
16 Auto-Answer - Press this switch to enable the innkeeper to automati-
cally answer an incoming call and then disconnect after the caller
hangs up. Auto answer will occur on the first ring.