JK Audio innkeeper 1x/rx - Manual (Page 4)

4
Features—Rear View
17 Caller Output - Male balanced XLR output contains only the
callers voice.
18 Mix Output - Male balanced XLR output contains a mix of send
and receive audio determined by the Send > Mix and Mix < Caller
level controls.
19 Send Input - Female balanced XLR input for signals going into the
phone line. Mic or line level input.
20 Remote Control Jack - 10 pin RJ-50 modular jack for connection
to the RS-232 cable (included), the optional JK Audio RIU-IP re-
mote interface or the optional JK Audio Guest Module 1 Remote
Keypad.
21 AC Power - Universal AC power input for 100-240 Volt, 50-60 Hz
supply current.
22 Phone Line - Connect to a standard, single line, analog telephone
line.
23 Aux. Phone - Connect a single line analog telephone for call setup /
dialing, or producer call screening.
24 Mic / Line switch - Sets the front end sensitivity of the Send XLR
jack. Set to Mic if you intend to plug a dynamic microphone
directly to the Send jack. Set to Line if you are connecting to a mic
mixer. This device does not provide phantom power for a con-
denser type microphone.
25 Remote Terminals - Screw terminals provide connections for a
small speaker, remote LEDs, tape recorder control, or console call
control switches.
22 24
25
17 18 19 20 21
23
13
Inputs
Send: Balanced Female XLR,1k ohms,
15 mV RMS (-34 dBm nom.)
Mic/Line pad switch, Line = +6 dBu max.
Outputs
Caller: Balanced Male XLR, 200 ohms,
500 mV RMS, -4 dBu nom, +12 dBu
Max.
Mix Out: Balanced Male XLR, 200 ohms,
500 mV RMS, -4 dBu nom, +12 dBu
Max.
Headphone: 1/4" Stereo, 8 ohms, 250 mW per channel
Speaker: Screw Terminals, 8 ohms, 1 watt
Remote Jack: RJ-50
Phone Line Jack: RJ-11C
Isolation: 1500 VAC
Ringer: 0.5B REN
Frequency Response: Telephone side 200 Hz - 3600 Hz
Power: Universal AC supply, 120-240 VAC,
50-60 Hz, 25 watts max.
innkeeper 1x
Size: 1.75" x 7.3" x 10.5" (4.5 x 18.6 x 26.7 cm)
Weight: 4.0 Pounds
innkeeper 1rx
Size: 1.75" x 7.3" x 19" (4.5 x 18.6 x 48.3 cm)
Weight: 5.4 Pounds
Operation (continued) Specifications