JK Audio innkeeper 1x/rx - Manual (Page 3)

3
Features—Front View
1 Call Button - Takes the line off-hook - press this button to answer a
call or you can direct a call from your aux phone through the hybrid.
2 Drop Button - Press this button to drop (hang up) a call.
3 Send Level - Adjusts the signal that you are sending down the
telephone line.
4 Caller Level - Adjusts the level of the signal coming in from the
telephone line, going out the “Caller” jack.
5 Send > Mix Level - Adjust the level of your audio that will be sent to
the “Mix Out” jack.
6 Mix < Caller Level - Adjusts the level of caller audio that will be sent
to the “Mix Out” jack.
7 Headphones - The stereo headphone jack contains the signal you have
created with the Send > Mix and Mix < Caller level controls. Both left
and right channels get the same signal.
8 Mix Monitor - Adjusts the mix signal level sent to the headphone and
rear panel speaker terminals.
9 Ring LED - Flickers when you have an incoming call.
10 OH LED - Lit when you are on line with a call (off-hook).
11 Signal LEDs - Send LEDs represent the signal level going out to the
telephone line. Receive LEDs represent the signal level coming from
the phone line, after the DSP.
12 AGC - press this switch to allow the innkeeper 1x/1rx to automatically
adjust the gain of caller audio so all callers are received at an average
level..
13 Caller Ducking - press this switch to lower the caller’s audio level by
9 dB when local audio is present.
14 Presence - press this switch to boost the low end of the caller audio
signal. Presence is added to the caller audio signal only.
15 1 kHz tone generator - press switch once to send a full scale 0 dB,
maximum output level 1kHz tone down the phone line, press again to
send this signal out the Caller jack, press a third time to turn off.
16 Auto-Answer - Press this switch to enable the innkeeper to automati-
cally answer an incoming call and then disconnect after the caller
hangs up. Auto answer will occur on the first ring.