JK Audio Outerloop - Manual (Page 14)

8
Outerloop Wireless Intercom Beltpack
Bluetooth Wireless Technology
Pairing to a Cell Phone with
Bluetooth Wireless Technology
When you're first connecting to a
new device, you should be in an
environment with no other Bluetooth
wireless technology enabled devices
within range that might also be in
Pairing Mode.
1. Starting with the Power switch Off,
set the Phone/Headset switch to the
Phone position.
2. Turn the Outerloop on, then hold
the Pair Button for 5 full seconds.
After you release the button, the
blue LED should flash rapidly if
Outerloop is in Pairing Mode.
3. On your device, find and select
the option to set up a connection.
When the cell phone has found
the new device, select from the list
the device ID. Depending on the
gender of model, the device ID is
"JKOTLFxxxx" or "JKOTLMxxxx"
where: xxxx = last four digits of the
serial number.
4. If asked for a pin, enter "0000".
5. When bonding is complete, the blue
LED will flash at a rate of 2 secs
off, 1 sec on. (2 secs off, 4 secs
on for HD Voice) Once Outerloop
has been added to your cell phone,
subsequent connections can be
made more quickly from Idle Mode.