JK Audio RemoteAmp Blue - Manual (Page 2)

2
JK Audio combines Bluetooth Wireless Technology
with professional audio electronics in a rugged new
belt pack design.
RemoteAmp Blue allows IFB monitoring through a
cell phone equipped with Bluetooth Wireless Tech-
nology. This is a listen only connection designed for
voice IFB or full bandwidth stereo music listening.
RemoteAmp Blue pairs to your cell phone like any
Bluetooth wireless headset. The line input jacks
and separate volume controls allow wired operation
in parallel with the Bluetooth connection. The XLR
line level input accepts either a balanced mono sig-
nal or a party line intercom feed (listen-only). The 1
watt, 1/4” stereo headphone jack will cut through
any crowd noise. Or you can connect an IFB ear-
piece to the 3.5 mm stereo earpiece jack.
BluePack also pairs to Bluetooth equipped sound
cards and music players in full bandwidth A2DP
stereo mode.
* The Bluetooth word mark and logos are owned by the
Bluetooth SIG, Inc. and any use of such marks by JK Audio,
Inc. is under license. Other trademarks and trade names are
those of their respective owners.
Description
15
FCC-B Part 15 Compliance
This device has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are de-
signed to provide reasonable protection against
harmful interference when the equipment is oper-
ated in a commercial environment. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accor-
dance with the instruction manual, may cause
harmful interference to radio communication. Op-
eration of this equipment in a residential area is
likely to cause harmful interference, in which case
the user will be required to correct the interference
at his/her own expense.
Changes or modifications not expressly approved
by JK Audio can void the user's authority to
operate the equipment.
Shielded interface cables and AC power cord, if
any, must be used in order to comply with the
emission limits.
The internal antennas used for this mobile trans-
mitter must not be co-located or operated in con-
junction with any other antenna or transmitter.
2
JK Audio combines Bluetooth Wireless Technology
with professional audio electronics in a rugged new
belt pack design.
RemoteAmp Blue allows IFB monitoring through a
cell phone equipped with Bluetooth Wireless Tech-
nology. This is a listen only connection designed for
voice IFB or full bandwidth stereo music listening.
RemoteAmp Blue pairs to your cell phone like any
Bluetooth wireless headset. The line input jacks
and separate volume controls allow wired operation
in parallel with the Bluetooth connection. The XLR
line level input accepts either a balanced mono sig-
nal or a party line intercom feed (listen-only). The 1
watt, 1/4” stereo headphone jack will cut through
any crowd noise. Or you can connect an IFB ear-
piece to the 3.5 mm stereo earpiece jack.
BluePack also pairs to Bluetooth equipped sound
cards and music players in full bandwidth A2DP
stereo mode.
* The Bluetooth word mark and logos are owned by the
Bluetooth SIG, Inc. and any use of such marks by JK Audio,
Inc. is under license. Other trademarks and trade names are
those of their respective owners.
Description
15
FCC-B Part 15 Compliance
This device has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are de-
signed to provide reasonable protection against
harmful interference when the equipment is oper-
ated in a commercial environment. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accor-
dance with the instruction manual, may cause
harmful interference to radio communication. Op-
eration of this equipment in a residential area is
likely to cause harmful interference, in which case
the user will be required to correct the interference
at his/her own expense.
Changes or modifications not expressly approved
by JK Audio can void the user's authority to
operate the equipment.
Shielded interface cables and AC power cord, if
any, must be used in order to comply with the
emission limits.
The internal antennas used for this mobile trans-
mitter must not be co-located or operated in con-
junction with any other antenna or transmitter.