Kessler CAMERA SLIDERS: Parallax Installation Guide - Manual

PARALLAX INSTALLATION GUIDE
What You’ll Need
• Slider (Note* Pocket Dolly V1 is not compatible - contact support)
• Pocket Dolly v2.0 Basic, Pocket Dolly V2.0, Stealth Slider, Philip Bloom Pocket Dolly,
Stealth Carbon, Philip Bloom Carbon
• Parallax rail assembly (Fig. A)
• 5/32” allen key (Fig. B)
• (2) 1/4”-20 custom countersunk screws (Fig. C)
• (2) 1/4”-20 countersunk screws (Fig. D)
• Parallax cart assembly (Fig. E)
Step 1b
This step is for 3’ (Standard Length) Carbon Sliders only if not adjusted from factory.
Move both left and right arms to inside slots by unscrewing the lever to match with
proper holes on slider.
™
Step 1a
Place Parallax rail underneath camera slider and line up to corresponding screw holes
Note* Remove the Crank Handle on the Pocket Dolly v2.0 for best use
Fig. A
slot
hole