Klimaire KTHM015-E5H2 PTAC Installation Manual - Manual (Page 8)

7
INSTALLATION
HOW TO INSTALL THE UNIT
- For existing sleeve,you shou ld measure the wall
sleeve dime n sions.
- Install the new air cond itioner according to these
installation instructions to a chieve the best performan ce.
All wall sleeves used to mount the ne w air conditioner
mu st be in goo d structural con dition and have a rear
grille that securely a ttaches to the sleeve or the flange
of the sleeve to secure the new air condition er.
- To avoid vibration and noise,m ake sure the unit is
installed securely and firmly.
- When installing the sleeve,make certain there is
nothing within 20 of the back that would interfere
with heat radiation and exhaust air flow. (See Fig.2)
!
CAUTION
There are sharp edges that can cause serious cuts.
When lifting the air conditioner,it is HEAVY.Use 2
peo ple to lift.
COO LED
AIR
INTAKE
AIR
WALL
WALL
HEAT
RADIATION
SLEEVE
Over 20
Fig.2
PREPARATION OF SLEEVE ASSEMBLY(optional)
- Refer to the installation instruction of sleeve assem bly
for details.
UNIT INSTALLATION
- Carefully remove shipping tape s from the front pan el.
(See Fig.3)
Fig.3
Shipping
tape
- Remove the shipping screw from the vent doo r.(See
Fig .5)
Fig.5
- Remove the fron t panel. (See Fig.4)
Shipping
screw
1 067mm/ 42i nch
40 8mm/1 6inc h
606mm/23.9inc h
Dim ension of air cond itioner
376mm/14.8inch
408mm/16inch
1067mm/42inch
Dim ension of slee ve assemb ly (op tiona l)
Fig.4
- Pull out at the bottom to release it from the tabs .
- Then lift up .
PREPARATION OF REAR GRILLE ASSEMBLY(optional)
- Refer to the installation instruction of rear grille
assem bly for details.