Krell S-1500 - Manual (Page 14)

Connecting the S –1500 Amplifier, continued
4. Connect the loudspeaker cables to the S –1500 amplifier chan-
nel output binding posts (5) located on the back panel.
The S –1500 / 5 uses only outputs 1-5, and has caps on the
loudspeaker binding posts of channels 6 and 7. The S–1500 / 6
uses outputs 1-6, and has caps on the loudspeaker binding
posts of channel 7.
The binding post terminals accept spade lugs, bare wire, or pins.
Use the red terminal for the positive connection and the black
terminal for the negative connection.
Tighten loudspeaker binding posts by hand only.
5. Plug the AC power cord into the amplifier’s IEC connector (8).
6. Plug the other end of the AC power cord into the AC wall outlet.
The amplifier is now ready for operation. See Operating the
S –1500 Amplifier,
on the next page.
The S –1500 / 5 and S –1500 / 6 amplifiers may be upgraded with addi-
tional channels, to make a total of seven. Please contact your Krell-autho-
rized dealer or distributor for information on upgrading your amplifier to
six or seven channels.
IMPORTANT
Note
INPUT AND OUTPUT
CONNECTIONS,
continued
14 Krell S–1500 Multi-channel Amplifier