Lighting the rotisserie burner, Match lighting the rotisserie burner, Lighting the side burner – Brinkmann ELITE SERIES 4685 User Manual

Page 21

Advertising
background image

LIGHTING THE ROTISSERIE BURNER:

1. Open grill hood before lighting rotisserie burner.

2. Make sure control knob is in the "OFF" position.

3. Push and turn the control knob of that burner to the "HIGH"

position. Continue to push in control knob while pressing
electronic igniter for 3 – 5 seconds.

4. Once burner is lit, continue to push and hold control knob

for 30 seconds.

5. If ignition does NOT occur in 5 seconds, turn control knob to

"OFF”, wait 5 minutes to allow gas to dissipate and repeat
lighting procedure.

6. To turn off, turn each control knob clockwise until it locks in the "OFF" position.

IMPORTANT: DO NOT use back rotisserie burner when main burners are in use.

NOTE: If burner does not light or flame is too low, you may have spider or other insect blockage in

burner. Refer to original owners manual.

MATCH LIGHTING THE ROTISSERIE BURNER:

1. Open grill hood before lighting rotisserie burner.

2. Make sure control knob is in the "OFF" position.

3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the lower edge of burner.

4. Push and turn the control knob of that burner to the "HIGH" position. Continue to push control knob

until burner is lit.

5. Once burner is lit, continue to push and hold control knob for 30 seconds.

6. If the burner does not light in five seconds, turn the control knob to "OFF" and wait 5 minutes for gas

to dissipate and repeat lighting procedure.

7. If the burner does not light within the first few attempts of match lighting, there is a problem with the

gas supply. Turn off the gas at the burner and at the source. DO NOT attempt to operate the grill until
the problem is found and corrected.

LIGHTING THE SIDE BURNER:

1. Open lid before lighting side burner.

2. Make sure control knob is in the "OFF" position.

3. Push and turn side burner control knob to the "HIGH"

position.

4. Press the electronic igniter on the main control panel and

hold for 3 – 5 seconds to light burner.

5. If ignition does NOT occur in 5 seconds, turn control knob to

"OFF", wait 5 minutes to allow gas to dissipate and repeat
lighting procedure.

6. To turn off, turn each control knob clockwise until it locks in

the "OFF" position.

NOTE: If burner does not light or flame is too low, you may have

spider or other insect blockage in burner. DO NOT
attempt to operate the grill until the problem is found and corrected.

20

Advertising