OSD Audio Soundsole 2.1 - Manual (Page 7)

IR REMOTE CONTROL
1. POWER - Press this button to turn the SOUNDSOLE 2.1 ON/OFF.
2. SRC; SOURCE- Press to select a connected source. The SOUNDSOLE 2.1 Front Panel Status LED will flash once to
indicate a change in input selection.
LINE IN1, AUX – 3.5mm input, from Headphone Jack ANALOG connection
LINE IN2, RCA – Left and Right Signal Level Stereo RCA Input, ANALOG.
Optical LINE IN – Digital Fiber Optic Input
3. VOLUME -/+ Press VOL (-) to reduce volume. Press VOL (+) to increase volume.
4. DSP Effect
– Advanced Digital Signal Processing which creates simulated surround sound from a stereo speaker
configuration. This will dramatically open up the sound stage making the appear to be coming from all over the room.
There are two choices for DSP settings. Typically you would use the Cinematic setting when watching a Video, Movie or
Television show. The Studio setting is recommended when listing to a 2 channel music source but does not guarantee
better sound but just different. It then comes down to a personal preference to the listener.
5. MUTE - Press this button once to mute the SOUNDSOLE 2.1. Press again to un-mute the SOUNDSOLE 2.1.
6. Press this button to initiate Bluetooth pairing mode. The Front Panel Status LED will rapid flash blue. The
SOUNDSOLE 2.1 will output a pairing code that will be picked up by any active Bluetooth device that is within range of
the SOUNDSOLE 2.1. Press to select a paired Bluetooth device. A Bluetooth device must be paired to the OSD AUDIO
SOUNDSOLE 2.1
for audio output. A paired Bluetooth device will remain ‘connected’ after changing inputs as long as
the Bluetooth device has not moved out of range, turned off or otherwise disconnected.
OSD Audio · 775 Columbia Street · Brea, CA 92821 · Tel: (562) 697-2600 · www.osdaudio.com Page 7